Feature：

Resistance to mechanical strength, heat resistance, abrasion resistance, chemical resistance, machinability, dimensional stability, good electrical properties. PEEK, PPS, TORLON, PI and other high-performance engineering plastics, has been widely used in the semiconductor and photovoltaic industry.

PEEK,(Polyetheretherketone)

High continuous use temperature (approximately + 260 ℃), with high rigidity and hardness, as well as unique high Tensile strength and fatigue strength. In addition the heat deformation (but 1.8Mpa heat distortion temperature of about 141 ℃, when you need to pay attention to the use of high temperature and high load) and chemical stability and taste. When the temperature reached 260 ℃ before the material has excellent dielectric properties, and resistance to energy ray irradiation.

Flake SHEET	Thick(mm)	Width(mm)	Long(M)
	0.1 ~ 0.5	170	200

PPS,(Polyphenylene Sulfide)

PPS is a reinforced, internally lubricated semi-crystalline polymer, it has good chemical and mechanical properties, high dimensional stability at high temperatures, including wear resistance, high load capacity and dimensional stability.

Flake SHEET	Thick(mm)	Width(mm)	Long(M/mm)
	0.2 ~ 2	500	200M / 500

POM (Polyoxymethylene，Polyacetal)

Asia is the world's POM usage fastest growing regions. Electronic and Electrical and steam locomotive industry accounts for more than 65% of the market.

1. The high crystallinity. (Crystallinity: monomeric POM75 ~ 85%, the copolymerization POM 70 ~ 75%)

2. abrasion resistance, fatigue resistance, good chemical resistance.

3. mechanical strength, especially rigidity, creep resistance and high elastic recovery rate.

Flake SHEET	Thick(mm)	Width(mm)	Long(M)
	0.2 ~ 4	500	100

N6.N6(M).N66 (Polyamide)(Nylon)

Nylon was the first to develop and is the largest number of engineering plastic materials, characteristics: Tg: 65 ℃, Tm: 255 ℃.

1. wear, a self-slip.

2. acid, oil-resistant, corrosion-resistant.

3. High temperature (HDT = 240 ℃)

4. toughness, resistance to low temperatures.

5. creep resistance, high mechanical strength.

6. self-extinguishing (UL 94 V-2).

7. The electrical properties, high resistance to dielectric strength.

8. The oxygen transmission rate is small.

Flake SHEET	Thick(mm)	Width(mm)	Long(M)
	0.2 ~ 3	500	200